LORD JMC-700K
Thermal-cure epoxy resin | LORD
LORD JMC-700K
PRODUCT DESCRIPTION:
LORD® JMC-700K coating is a thermal-cure epoxy resin specially designed for thin film coating of heat sinks and magnets. LORD JMC-700K coating provides electrical insulation, heat resistance, and oil resistance with a single coat application. This coating can be used in a variety of automotive applications including cooling plates, heat sinks and motor magnets used in electric vehicles, as well as automotive parts and industrial machine applications.
Features and benefits:
Good adhesion – provides strong adhesion to substrate.
Broad temperature range – can be used on parts and devices that experience operating temperatures from -40°C to +180°C.
Environmentally resistant – provides excellent resistance to heat, oil and moisture.
Heat resistance test 180˚C x 1500 hrs | Pass |
Cycle test -40˚C to +170˚C, 1500 cycles | Pass |
Oil resistance test 150˚C x 2000 hrs | Pass |
Humidity resistance test 85˚C, 85% RH x 2000 hrs | Pass |
Application:
Surface preparation – thoroughly clean surfaces prior to coating application to remove all dirt, oil, grease and oxides.
Mixing – thoroughly stir the coating before use. If dilution is needed, use LORD JMC-700ST thinner or methyl ethyl ketone (MEK) as a dilatant.
Applying – apply coating using dip or spray methods. Regardless of the application method, the recommended dry film thickness of LORD JMC-700K coating is 10-100 micron.
Curing – allow coating to cure for 30 minutes at 180°C. This time-at-temperature profile refers to the time the material should be allowed to cure once it reaches the target temperature. Allowance should be made for oven ramp rates, parts with large thermal mass and other circumstances that may delay the material actually reaching the target temperature.
Typical properties*
Appearance | A black Liquid |
Viscosity, mPa-s @ 25˚C | 6000 |
Specific gravity | 1.07 |
Solids content by weight, % | 39.5 |
*Data is typical and not to be used for specification purposes. |
Applications:
- EV battery - cooling plates, heat sinks and motor magnets
- General - automotive parts and industrial machine applications
For complete product information, please refer to lord.com.
Graco system solution:
Graco provides a complete dispensing solution for LORD JMC-700K. Designed for the application of plural component intumescent fire protection coatings for battery applications, the Graco system is the first and only complete system equipped to dispense this advanced material. Our fully automated system provides a thorough and effective coating ideal for high-volume production.
Contact an expert
Recommended products
For applying LORD JMC-700K
Related articles
Fireproofing for an EV battery
Considering the role fireproofing plays in the safety of lithium-ion batteries, proper spray equipment is crucial to providing high-quality passive fire protection (PFP) coatings.
Electric vehicle thermal management
Whether it’s assembling electric vehicle (EV) batteries, and electronic products, or miniaturizing printed circuit boards (PCBs), thermal management remains crucial to longevity, efficiency and safety.
Battery Pack sealing - EV battery
A quality seal is critical for the performance and longevity of EV batteries and for protecting integral components from water intrusion and other harsh environmental conditions.